Installation Guide

20
Press the STOP button to turn the power ON or OFF.
*
If the power is ON, the power LED on the indicator panel will light up.
be on.
STOP (Turning the power on/off)
Performing the following operations before using the bidet allows you to use
the toilet comfortably.
Adjust the temperature of the toilet
seat using the Seat Temp. switch.
Adjust the temperature of the bidet
using the Water Temp. switch.
For Side Panel:
The water temperature can be set to one of 3
settings: HI, MID and LO.
For Remote Control:
The water temperature can be set to one of 5
settings
Set it to your preferred temperature.
* The indicator LED cycles through the temperature
settings each time the temperature button is pressed.
* The indicator LED stays on to indicate water
temperature level.
* 2 additional settings above default, for side panel only
For Side Panel:
The seat temperature can be set to one of 3
default settings: HI, MID and LO.
For Remote Control:
The seat temperature can be set to one of 5 settings.
Set it to your preferred temperature.
* The indicator LED cycles through the temperature
settings each time the temperature button is pressed.
* The indicator LED goes out after several seconds.
* 2 additional settings above default, for side panel only
• The toilet seat will not become warm instantly. To achieve
a comfortable seat temperature, set the seat to the desired
temperature about 10 to 15 minutes prior to use.
• This product is equipped with an ECO function that
automatically switches the seat heater off when it is
not occupied.
• The default setting for the seat temperature is "MID". The seat
temperature can be increased or decreased incrementally.
Reference
Preparations Before Use
Seat Temp.
Remote Control
Side Panel
Water Temp.