Specification Sheet

FIAT
R
255 Hutchings St. • Winnipeg, MB • R2X 2R4 • Ph. 800-665-7531 • 204-633-6122 • Fx. 204-632-4854
e-mail: [e-mail] • website: www.fiat.ca
A subsidiary of CR/PL, L.L.C. Company – Evanston, IL
Service-Sink Faucet
Model: 830-AA
General:
Material:
Finish:
Specifications
and
Codes:
830-AA Service Faucet - Chrome plated with
vacuum breaker, integral stops, adjustable wall
brace, pail hook and
3
/4” hose thread on spout.
Body inlets 8” center to center, four arm
handles. Valves contain renewable hub,
renewable seats, swivel discs, encased washers
and brass washer screws.
Commercial red brass alloy casting-rough finish.
Chrome plating exceeding requirements of
ANSI/ASTM B-456-71. Indicators cold (blue) and
hot (red) are included.
In the U.S.A., meets or exceeds requirements of
ANSI-A112.18.1M-1979 for “Finished and
Rough Brass Plumbing Fixture Fittings.” In
Canada, meets or exceeds the requirements of
CSA standards B125 - “Plumbing Fittings,”
B64.1.1 - “Vacuum Breakers - Atmosphere
Type” and B64.0 - “General Requirements for
Backflow Preventers and Vacuum Breakers,”
and is approved under Product Class No. 6811
01 under Report #LM57412-1. Conforms to
ASSE 1001.
NOTE: These roughing measurements may
vary 1/4” (plus or minus).
3/4” (19) HOSE THREAD
VACUUM BREAKER
9-3/8” (238)
2-7/8” (73)
3/4” (19)
1/2” (13) I.P.S.
MALE THREADS
1/8” (3) ECCENTRIC
9” (229)
APPROX.
BUCKET
HOOK
1-1/2”(38)
SIDE VIEW
FRONT VIEW
INTEGRAL STOPS
2-3/8” (60) DIA.
HOT COLD
8” (203)
33888_830-AA Faucet Spec. Sheet 2/27/2003 4:32 PM Page 1