Installation Guide

1
The WALL MOUNTED ACCESSORIES work best if secured to a wall stud or cross brace within the wall, using the SCREWS (2) supplied.
If the ACCEASAORY is to be installed on a tile or plaster wall, the ANCHORS (3) and SCREWS (2) should be used.
Secure MOUNTING BRACKET (1) to wall with SCREWS (2).
Determine desired height and location (optional) and mark a center line. Make sure the centerline is level. Using the MOUNTING
BRACKET (1) as a template, mark the two spots for the mounting holes. If MOUNTING BRACKET (1) is secured to a stud or cross
brace, drill small pilot holes for SCREWS (2).
For installations on tiled walls or drywall, use TILE ANCHORS (3) and SCREWS (2) for securing MOUNTING BRACKET (1) to wall. Drill two
1/4" diameter holes a minimum of 1-1/4" deep. Insert the two TILE ANCHORS (3) flush with face of finished wall. Place MOUNTING
BRACKET (1) over TILE ANCHORS (3) and insert SCREWS (2) provided with a flat blade screwdriver. See illustration below.
M965366 REV. 1.2 (12/14)
INSTALLATION OF MOUNTING BRACKETS
FOR ALL WALL MOUNTED ACCESSORIES
Thank you for selecting American-Standard...the benchmark
To ensure that your installation proceeds smoothly--please
read instructions carefully before you begin.
2
DRILL PILOT HOLE FOR
WOOD SCREW (2) OR
1/4" DIA. HOLE FOR
ANCHOR (3)
1
1
3
3
Installation
Instructions
C SERIES
Casual Bath Accessories
CARE INSTRUCTIONS:
8337.018
8337.024
8337.190
8337.210
8337.230
8337.524
8337.506
18" TOWEL BAR
24" TOWEL BAR
TOWEL RING
DOUBLE ROBE HOOK
TOILET PAPER HOLDER
24" SHOWER DOOR HANDLE
6" SHOWER DOOR HANDLE
3/8" (9mm)
3/4" (19mm)
2
LEVEL
C
L
FINISHED WALL
Recommended Tools
Phillips Screwdriver
10'
Tape Measure
Electric Drill
Level
4mm Hex wrench
DO: CLEAN WITH CLEAR WATER. DRY WITH A SOFT
COTTON FLANNEL CLOTH.
DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS,
ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A
CLOTH WITH A COARSE SURFACE.
Flat Head Screwdriver

Summary of content (5 pages)