Installation Guide

ManualsBrandsAmerican Standard ManualsKitchen12 in. x 14 in. Kitchen Sink Grid for Portsmouth 32 in. x 18 in. Double Bowl Kitchen Sink in Stainless Steel

NOTE: To avoid damage to

countertop, install sink such that

future removal from underneath

the countertop is possible.

First, make sure the clearance

between the backsplash, faucet,

fixtures and cabinets are

acceptable for the new sink.

Carefully cut out the enclosed template, then position and trace

the template on the countertop as shown on the template.

Make a mark of the faucet hole centerline on the countertop.

Drill a 1/2" pilot hole on the inside of the cut line. Use a saber

saw or a keyhole saw to cut out the countertop opening.

7302243-100 Rev. B 3/17

PERIMETER OF SINK

CUTOUT

1/2 MIN.

Clip

1/2 MIN.

Clip

FOR MARBLE OR SOLID SURFACE COUNTERTOP

FOR WOOD COUNTERTOP

Mark and pre-drill the wood screw holes as located on the

enclosed template. Waterproof any exposed areas of wood.

To protect countertop, place it on a foam padding

and drill 3/8 Dia. x 1/2 deep hole as per location

shown on template.

Drill 1/8 dia. x 3/8 deep

#10 Wood Screw

Brass insert, epoxy in place

with threaded end exposed.

(Epoxy not supplied.)

#10-32 Machine screw

CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE!

NOTE: Pictures may not exactly define contour of china and components.

INSTALLATION INSTRUCTIONS

Undercounter Sink

0545 Edgemere

™

Sink

Introduction: Thank you for selecting our products...products which have been the benchmarks of fine quality for years. To help

ensure that the installation process will proceed smoothly, please read these instructions carefully before you begin. Also, review

the recommended tools and materials list; carefully unpack and examine your new plumbing fixture.

Product names listed herein are trademarks of AS America, Inc.

Recommended Tools & Materials

Observe Local Plumbing and Building Codes.

Product names listed herein are trademarks of American Standard Inc. unless otherwise noted.

Adjustable Wrench Channel Lock Pliers

Regular Screwdriver

Phillips Screwdriver

10'

Pipe Wrench

Putty Knife

Silicone Adhesive

Basin Wrench

Plumbers' Putty

Tubing Cutter

Tape Measure

Hacksaw

Saber Saw

NOTE: More specialized tools may be necessary to install this sink to

countertop materials other than wood or wood composites.

Drill

SAVE FOR FUTURE USE

Summary of content (2 pages)

PAGE 1
INSTALLATION INSTRUCTIONS Undercounter Sink 0545 Edgemere™ Sink Introduction: Thank you for selecting our products...products which have been the benchmarks of fine quality for years. To help ensure that the installation process will proceed smoothly, please read these instructions carefully before you begin. Also, review the recommended tools and materials list; carefully unpack and examine your new plumbing fixture. ! CAUTION: PRODUCT IS FRAGILE.
PAGE 2
5 6 Mount the drain assembly (not included) on the sink, following faucet manufacturer's instructions. Be certain to apply a bead of sealing putty on the underside of the drain (Part "A") in order to ensure a watertight seal between the sink and drain. Remove excess putty after installing drain on sink. NOTE: Do not use adhesives or adhesive sealants. After checking fit and alignment of sink to cut out, apply a bead of silicone adhesive to rim of sink.