Installation Guide

ManualsBrandsAmerican Standard ManualsBathroomStudio S 24 in. Double-Drawer Bathroom Vanity in Dark Grey

SAVE FOR FUTURE USE

770278-100 Rev. 1 05/2020

CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE!

NOTE: Pictures may not exactly define contour of china and components.

Studio

8725/8726 Series Vanity / Vanity Top

INSTALLATION INSTRUCTIONS

CARE AND MAINTENANCE

Thank you for selecting American Standard - the benchmark of fine quality for over 100 years. To ensure this product is installed properly, please read these

instructions carefully before you begin. (Certain installations may require professional help.) Also be sure your installation conforms to local codes.

OBSERVE LOCAL PLUMBING AND BUILDING CODES

Recommended Tools

Recommended Materials

Studio

S 24" Single Vanity

Studio

S 33" Single Vanity

Adjustable Wrench

Putty Knife

Channel Lock Pliers

Regular Screwdriver

Phillips Screwdriver

Saber Saw

Basin Wrench

Tubing Cutter

Tape Measure

Pipe Wrench

Drill

Plumbers' Putty

or Caulking

Hacksaw

Level

24"

(609 mm)

20"

(508 mm)

2-7-16"

(62 mm)

20"

(508 mm)

10-13/16"

(275 mm)

(174 mm)

12-5/8"

(320 mm)

19-11/16"

(500 mm)

13-1/8"

(334 mm)

1-3/16"

(30 mm)

*18-1/4"

(334 mm)

*23-3/16"

(589 mm)

23"

(583 mm)

9-13/16"

(250 mm)

34-1/16"

(866 mm)

22-1/16"

(560 mm)

Ø7/8"

(22 mm)

16-3/4"

(425 mm)

13-16"

(20 mm)

FAUCET MOUNTING HOLES:

SINGLE HOLE OR 8" (203mm)

20"

(508 mm)

(174 mm)

12-5/8"

(320 mm)

19-11/16"

(500 mm)

13-1/8"

(334 mm)

1-3/16"

(30 mm)

*18-1/4"

(334 mm)

*23-3/16"

(589 mm)

23"

(583 mm)

9-13/16"

(250 mm)

34-1/16"

(866 mm)

31"

(788 mm)

Ø7/8"

(22 mm)

16-3/4"

(425 mm)

13-16"

(20 mm)

33"

(838mm)

10-13/16"

(275mm)

20"

(508mm)

FAUCET MOUNTING HOLES:

SINGLE HOLE OR 8" (203mm)

2-7/16"

(62mm)

Product names listed herein are trademarks of AS America, Inc.

3 #10 x 2" wood screws

Summary of content (6 pages)

PAGE 1
INSTALLATION INSTRUCTIONS CARE AND MAINTENANCE Studio® S 8725/8726 Series Vanity / Vanity Top Thank you for selecting American Standard - the benchmark of fine quality for over 100 years. To ensure this product is installed properly, please read these instructions carefully before you begin. (Certain installations may require professional help.) Also be sure your installation conforms to local codes. ! CAUTION: PRODUCT IS FRAGILE.
PAGE 2
1 Wall Preparation For Vanity Installation Provide suitable reinforcement behind finished wall for vanities mounting cleat. Vanity must be mounted to a solid wall surface behind the wall. Note: If replacing an existing sink be certain to shut off water supply prior to removing old sink.
PAGE 3
5 Installing Vanity Cleat Line Place cleat on line, check level and screw in place using 3 #10 x 2" wood screws. 6 Cleat Installing Vanity Onto Cleat Place vanity onto cleat on the wall and check for level in two directions, front to back and side to side. Shim as needed to ensure vanity is level. 7 Faucet And Drain Installation Following manufacturer’s instructions, install faucet and drain assembly (not included).
PAGE 4
9 Sink To Vanity Installation a) Apply a bead of caulk or adhesive around all 4 sides of the top edge of the vanity where the sink will sit. Refer to Illustration. b) Place the sink onto the vanity and carefully over the trap assembly ensuring sink sits evenly (left to right) over the vanity and against the rear wall. See Illustration. c) Clean up any adhesive that may run out. d) Connect hot and cold supply lines between the fitting valve and the supply shut-off valves.
PAGE 5
11 Connecting Optional Bridge to Vanities PRE-DRILLED SCREW HOLE From inside the vanity there are 4 pre-drill locations, screw into each pre-drill location from the vanity into the bridge using supplied #6 1-1/4" screws connecting bridge to vanity. If a second vanity is being used, install 4 #6 1-1/4" screws into the 4 pre-drilled locations in the second vanity into the bridge.
PAGE 6
FURNITURE CARE INSTRUCTIONS: Rinse the product clean with clear water. Dry with a soft cotton flannel cloth. DO NOT: Clean with soaps, acid, polish, abrasives, harsh cleaners, or a cloth with coarse surface. AS AMERICA, INC. BATHROOM FURNITURE LIMITED WARRANTY If inspection of this AS America, Inc.