Specification

M965625 REV. 1.1 (11/14)
1
INSTALL VALVE TRIM
1
Figure 1.
Figure 2.
Figure 3.
2
1
3
3
5
6
4
Figure 1. Remove plaster guard from valve. Push CAP (1)
over VALVE CARTRIDGE (2) until seated against stop.
Figure 2. Push ESCUTCHEON (3) onto CAP (1). Align
mounting holes in ESCUTCHEON (3) with valve body.
Attach to valve body with LONG SCREWS (4).
Figure 3. Align PIN (5) on back of DIAL PLATE (6) with
hole in ESCUTCHEON (3). Push DIAL PLATE (6) onto
CAP (1) flush against ESCUTCHEON (3).
3
INSTALL HANDLE
3
1
5
Hold ADAPTER (1) onto VALVE STEM (2) and install
ADAPTER SCREW (3) through ADAPTER (1) into
VALVE STEM (2).Tighten ADAPTER SCREW (3) to
secure ADAPTER (1).
Align and install HANDLE (4) onto ADAPTER (1).
Tighten SET SCREW (5) with HEX WRENCH (6)
supplied.
2
6
PLSTER
GUARD
HOLE IN ESCUTCHEON (3)
5
1
2
5a
6
7
3
APPLY SEALANT OR
TEFLON TAPE TO
THREADS
4
2
INSTALL TRIM
Remove PIPE PLUG and CAP (1, 2) from shower pipe and tub
filler pipe.
Install SHOWER ESCUTCHEON (3) onto SHOWER
ARM (4). Apply sealant or Teflon tape to threads on
both ends of SHOWER ARM (4) and thread longer
leg of SHOWER ARM (4) into shower elbow.
Thread SHOWER HEAD (5 or 5a) onto SHOWER ARM (4).
Install SLIP-ON TUB SPOUT (6). Tighten SET SCREW (7) with
HEX WRENCH supplied.
Important: Do not overtighten Set Screw.
CAUTION: Protect finish on SHOWER HEAD
and TUB SPOUT when installing.
Note: Apply sealant or Teflon Tape to shower arm.
HEX WRENCH
1-3/4"
4
1
O f f
C
H
O f f
C
H