Use and Care Manual

7302365-100
4
Vanity Top Installation:
Using the template provided, locate the position of the sink
on the above counter. Provide proper clearance under the
countertop for the faucet supply lines, drain assembly and
the structural parts of the cabinet.
NOTE: If replacing an existing sink be certain to shut off
water supply before removing old sink.
Vanity Top Installation:
• Place the sink temporarily into the sink opening
• Check for alignment and clearance
• Mark the sink and countertop in several places
as a guide for the final installation location.
Connect supply line to faucet (finger tight) and carefully bend
tubes to engage with the supply shut-off valves. Tighten
connections at faucet and shut-off valves for secure seal.
Shut-Off Valves
B
C
After checking fit and alignment, turn sink upside down and
apply a generous portion of silicone adhesive around the
under side of the rim near the edge. Place sink in position.
Wipe off excess adhesive.
Mount the faucet and drain assembly (not included) on the sink
following the manufacturer’s instructions. Be certain to apply a
bead of sealing putty on the underside of the drain (Part “A”) in
order to ensure a watertight seal between the sink and drain.
Remove excess putty after installing drain on sink.
A
Drill a clearance hole inside the perimeter line of the
template for above counter installation.
Cut opening around the perimeter of the template.
Perimeter of
template
Perimeter of
template
1
5
6
6
7
2
3
4
Connect trap to drain assembly hand tight to check alignment. It
may be necessary to cut off part of the tailpiece (area “B”) or
part of the horizontal leg of the trap (area “C”). Secure joints for
watertight assembly.