Installation Guide

770034-100 Rev. A
-6-
Threaded Leveler (1 per pack) for Tropic 20" Vanity Base730679-0070A
REPLACEMENT PARTS LIST
9212020 Tropic 20" Vanity | 9212400 Tropic 20" Vanity Base
REPLACEMENT
PART NO.
DESCRIPTION
B
C
A
WALL HUNG CONFIGURATION
FLOOR STANDING CONFIGURATION
TROPIC 20" VANITY
9212020
TROPIC PETITE
PEDESTAL SINK
(0403.008 SHOWN)
DOORS OPEN
TO ACCESS
STORAGE
TROPIC 20" VANITY
9212020
TROPIC 20"
VANITY BASE
9212400
TROPIC PETITE
PEDESTAL SINK
(0403.008 SHOWN)
DOORS OPEN
TO ACCESS
STORAGE
TROPIC PETITE PEDESTAL SINK 0403.004 or 0403.008 INSTALLATION onto VANITY…
Two people recommended for this installation
Mount the drain assembly (not included) on the sink. Be certain to apply
a bead of sealing putty on the underside of the drain (Part "A") in order to ensure
a watertight seal between the sink and drain. Remove excess putty after installing
the drain on the sink.
Apply a bead of silicone adhesive to the rim of the vanity. Place the Tropic Petite Pedestal
Sink centered left to right on the vanity and with the back edge of the sink even with the
rear of the vanity.
If possible, apply a bead of silicone along the top back edge of the sink and the wall.
Clean up any excess silicone.
Connect the trap to the drain assembly hand tight to check alignment. It may be necessary
to cut off part of the tailpiece (area "B") or part horizontal leg of the trap (area "C").
Install the faucet as per the manufacturer’s recommendations.
Connect hot and cold supply lines to the shut off valves.
Tighten trap joints for watertight assembly.