Installation Guide

755472-100 Rev. 3 10/19
1 2
Ensure that the floor and stud walls are square and plumb on a
level floor as shown in Figure A. Provide a 6" x 6" (152 x 152mm)
opening in the floor for the drain and refer to the product rough-in
for actual drain location. The lower portion of the drain mount must
fit into the 6"x 6" (152 x 152mm) opening. Check by dry fitting the
shower base in the final location. Draw a line 2-1/8" (54mm) above
the level subfloor on the wall studs at each side of the opening.
FIGURE A
90°
90°
2" (51mm)
PVC Waste Pipe
Opening 6" x 6"
(152 x152mm)
C/L
(See Product Rough-In for Drain Location)
MARK STUDS 2-1/8" (54mm)
ABOVE LEVEL SUBFLOOR
2
A8009D-FCO
DRAIN ASSEMBLY
Strainer
Drain
Body
Shower
Base
Silicone
Sealant
Rubber
Gasket
Fiber
Gasket
Locking
Nut
Rubber
Caulking
Gasket
FIGURE B
All of the shower bases require purchasing a round shower
strainer type drain for use with a standard 2" (51mm) plastic
schedule 40 waste pipe. Figure B shows the typical drain
assembly. Before installing drain into the shower base, remove
strainer. (Fig B) This will be installed after shower base is in its
final position. Cut the waste pipe height so that the drain body
will fit snug in the shower base. Apply silicone sealant between
the drain body and shower base.
NOTE: Drain not included and must be purchased separately.
TOP VIEW
38"
(965mm)
38"
(965mm)
19"
(483mm)
18-1/2"
(470mm)
RIGHT SIDE
1-1/8"
(29mm)
1"
(25mm)
13/16" (21mm)
THRESHOLD DEPTH
3/16" (5mm)
BELOW THRESHOLD
FRONT
CO
3-1/4"
(83mm)