Installation Guide
- 2 -
755467-100 Rev. 3 07/20
2
1
Ensure that the oor and stud walls are square and plumb on a level oor as shown in Figure A. Provide a 5" x 5" (127 x127 mm)
opening in the oor for the drain and refer to the product rough-in for actual drain location. Draw a line 3-1/4" (82 mm) above the
level suboor on the wall studs at each side of the opening.
All of the shower bases require purchasing a round shower strainer type drain for use with a standard 2" (51 mm) plastic
schedule 40 waste pipe. Figure B shows the typical drain assembly. Before installing drain into the shower base, remove
strainer. (Fig B) This will be installed after shower base is in its nal position. Cut the waste pipe height so that the drain body
will t snug in the shower base. Apply silicone sealant between the drain body and shower base.
NOTE: Drain not included and must be purchased separately.
FIGURE A
90°
90°
2" (51 mm)
PVC Waste Pipe
Opening 6" x 6"
(152 x152 mm)
C/L
(See Product Rough-In for Drain Location)
MARK STUDS
ABOVE LEVEL SUBFLOOR
DRAIN ASSEMBLY
Strainer
Drain
Body
Shower
Base
Silicone
Sealant
Rubber
Gasket
Fiber
Gasket
Locking
Nut
Rubber
Caulking
Gasket
FIGURE B
FIGURE A
FIGURE B