Installation Guide

- 3 -
755467-100 Rev. 3 07/20
3
5
4
Mix a non-shrinking bedding material such as mortar and apply enough bedding material to support the entire bottom
of the shower base.
Concrete is NOT recommended. The shower base is NOT to be supported by the base flange.
Tape over the strainer to protect the nish and prevent construction debris from entering the drain.
Finish installation as shown in Figure E.
FIGURE E
Shower
Base
Tile
Adhesive
Waterproof
Drywall
Tile
Stud
Caulk
FIGURE D
Level base in two directions.
Level
Level
After the bedding material has been poured and before it sets, lower the shower base into position with the drain assembly
sliding over the waste pipe (Fig. C). It will be necessary to “rock” the shower base until the top of the tile ange aligns with
the lines drawn on the stud walls from Step 1. Make sure the apron is contacting the rough oor along the entire length of the
shower base and ensure that the base is level in two directions as shown in Figure D.
Note: Allow the bedding material to completely harden before applying weight to the bottom of the shower base.
Place strainer back into place and conduct a water test of drain and plumbing to ensure there are no leaks.
2 x 4"
(51 x 102mm)
Stud Wall
Bedding
Material Area
5" (127mm)
2" (51mm)
PVC Pipe
3-1/2"± 1/8"
(89± 3mm)
BEDDING MATERIAL
SUPPORTS
SHOWER BASE
NO BEDDING
MATERIAL UNDER
BASE FLANGE
CROSS SECTION OF
SHOWER BASE
ROUND SHOWER
STRAINER TYPE DRAIN
FIGURE C
FIGURE C
FIGURE E
FIGURE D