Specifications
7 69-1832—03
Done Next
To begin, press and hold the and fan
buttons until the display changes
1
3
5
9
12
13
14
15
16
27
28
31
System type
Fan control
(heating)
Heating cycle rate
(CPH: cycles/hour)
Compressor
cycle rate (CPH)
System setting
adjustment
Adaptive Intelligent
Recovery™
Temperature
display
Compressor
protection
Schedule format
Heat temperature
range stops
Cool temperature
range stops
Dehumidification
Control
0 Gas, oil or electric heat with air conditioning
1 Heat pump
2 Heat only (2-wire systems/power to open & close zone valves/
normally open zone valves)
3 Heat only with fan
4 Cool only
0 Gas or oil furnace — equipment controls fan in heating
1 Electric furnace — Comfort Control controls fan in heating
5 For gas or oil furnaces of less than 90% efficiency
1 For steam or gravity systems
3 For hot water systems & furnaces of over 90% efficiency
9 For electric furnaces
[Other cycle rate options: 2, 4, 6, 7, 8, 10, 11 or 12 CPH]
3 Recommended for most compressors
[Other cycle rate options: 1, 2, 4, 5 or 6 CPH]
0 Manual changeover (Heat/Cool/Off)
1 Auto changeover (Heat/Cool/Auto/Off) **See page 9
2 Auto changeover only (Auto) **See page 9
1 On **See page 9
0 Off
0 Fahrenheit
1 Celsius
5 Five-minute compressor off time **See page 9
[Other options: 0, 1, 2, 3 or 4-minute off time]
0 5/2 (programmable weekdays and weekends)
1 5/1/1 (weekdays, Saturday & Sunday programmable)
90 Highest heating temperature setting
40-89 Heating temperature range (increments of 1°F, or 0.5°C)
60 Lowest cooling temperature setting
61-99 Cooling temperature range (increments of 1°F, or 0.5°C)
1 Cooling Droop
2 Cooling Droop with Comfort-R
TM
(15 seconds Fan Delay)
3 Cooling Droop with Comfort-R
TM
(30 seconds Fan Delay)
0 None
Setup Function Settings & Options (BOLD is “as shipped” settings)
Function
number
Press or to change settings
Press next to advance to next function
Press done to exit and save settings
Setting
Installer setup
Follow the procedure below to configure the Comfort Control to match the
installed heating/cooling system, and customize feature operation as desired.