Specifications

38 BAS-SVX36C-EN

Operation

To set the schedule:

1. Press > > > .The display shows only the following elements:

2. Press .

Note: At

this point the thermostat is in schedule change mode. It returns to normal operating

mode if no buttons are pressed for 45 sec.To manually exit schedule change mode, press

and hold for 2 sec.

Note: If flashes and you are unable to enter schedule change mode, the mode is locked. See

“Locking or Unlocking Modes,” p. 40.

3. Press or to select the day or days for which you want to set the schedule.The selected day

or days flash.

4. Press to accept the selection. , , ,or

starts flashing.

5. Press or to select the period.The selected period starts flashing.

6. Press to accept the selection.The start time starts flashing.

7. Press or to select the start time.Time is increased or decreased in 10 min steps.

8. Press to accept the selection. If there is a heat mode configured, the heat setpoint appears

and its icons start flashing.

9. Press or to select the heating setpoint.

Note: The

heating and cooling setpoints cannot be closer together than the deadband, which

is specified in installer configuration option #0181 (see “Configuration,” p. 26). If you

raise the heating setpoint or reduce the cooling setpoint to a value that would violate

the

deadband setting, the opposing setpoint will also adjust to maintain the deadband.

10. Press to accept the selection. If there is a cool mode configured, the cooling setpoint

appears and its icons start flashing.

11. Press or to select the cool setpoint.

12. Press to accept the selection. or starts flashing.

13. Press or to select the fan setting.

• to

turn it on and off automatically

• to keep the fan on continuously

14. Press to accept the selection.This completes the schedule settings for one period of one

day of the week.

15. Repeat Step 3 through Step 14 once for each day and period you need to set.

Mo Tu We Th Fr Sa Su