Installation Guide

710015-100
2
1
INSTALLATION PROCEDURES:
Before installing rollers, hangars, and towel bars, please
see side view of a completed door above.
NOTE: Screwheads for roller screws and hangar screws are
located between two panels.
Painted or rough side (if any) of both panels should
face the outside of shower.
2
Carefully remove panels from carton and place on a towel
or other soft surface.
Mount nylon rollers in the center of slots of larger hangar
piece with roller on smooth side.
Apply silicone caulk as shown.
Position large and small hangars on top of glass 2" from
the edge. Clamp together so top indentation of hangar
assembly rests on top edge of glass. Insert screws
opposite side of rollers as shown, alternately tightening
each of the three screws.
Trim excess silicone with sharp knife after it has set.
NOTE: Allow silicone caulk to cure while proceeding with
following steps.
INSIDE
OF
SHOWER
(ACTUAL SIZE)
LARGE HANGAR
SMALL HANGAR
CAULK
CAULK
(ACTUAL SIZE)
HANGAR SCREW
ROLLER SCREW
ROLLER