Installation Guide

710015-100

Install header over each top end of wall jambs.

Drill a 1/8" hole through header and into wall jamb from

inside shower at each end (1/4" from the wall).

Fasten header to wall jambs with screws provided.

Install inside door panel by lifting up inside top track and

hanging rollers on groove. Please be careful not to touch

bottom edge of glass panels with bottom track when hanging

rollers on track.

Ensure that rollers are properly seated and panel glides on top

track before releasing panel. Repeat for outside door panel.

If panels are not parallel to wall jambs, remove and adjust

rollers up or down in roller slots.

At center of bottom track, slide center guide under inside panel

as shown and attach with screw.

To attach towel bar, put washer and plastic grommet over

towel bar screw.

Place a washer and towel bar on other side of glass and

thread screw loosely into towel bar.

Hand tighten after all four screws are in place. If towel

bar loosens over time, put a cloth over edge of screws

and tighten.

1. Caulk the gap at both ends of bottom track wall jambs.

2. Caulk along inside wall jambs.

NYLON GUIDE

ACTUAL SIZE

CAULK