Use and Care Guide

710015-100

Remove bottom track and drill 3/16" holes for screw

anchors on wall as shown in Step 6. In ceramic tile

use a masonry drill bit and nick surface glaze first with a

center punch.

After drilling, clean tub rim or stall threshold thoroughly to

assure proper adhesion of bottom track. Insert screw

anchors provided.

Apply silicone caulk to bottom of bottom track as shown

and replace bottom track on ledge in previously marked

location.

NOTE: High edge of bottom track should face outside

edge of shower or tub. Carefully wipe off any excess caulk

(try not to move bottom track).

Install wall jambs and secure with wall screws provided.

Ensure wall bumpers are installed as shown.

Measure wall to wall opening at top of jambs and cut top

track 1/16" shorter than actual measurement to allow

for clearance.

Select style of top track, curved or flat.

OTHER

WALL JAMB SCREWS

(ACTUAL SIZE)

WALL JAMB SCREW

FOR BUMPERS

(ACTUAL SIZE)

BUMPERS

CAULK

UPSIDE DOWN

BOTTOM

TRACK

SCREW ANCHOR

(ACTUAL SIZE)

For best results, use a 32-tooth hacksaw blade and

a miter box.