Use and Care Guide

710015-100

Measure length D in the center of the tub ledge

NOTE: (if a steel tape is used, be sure to add the width of the

case to the measurement.)

Cut bottom track 3/16" shorter than length D. Do not cut top

track at this time.

Measure length of bottom track to determine center position.

Using center guide as a template, drill a 1/8" hole in bottom

track (see picture). Place center guide to the side for future

installation (see step 12).

Temporarily place bottom track on ledge at least 3/4"

in from outside edge and leaving small gap at each end

for wall jamb (high edge to outside of tub).

Fasten in place temporarily with masking tape.

Mark its position with a pencil.

5 6

Use a level to plumb wall jamb as shown and mark the

3 hole locations.

Repeat procedure at opposite side with other jamb.

Close tub drain before proceeding.

JAMB

LEVEL

WALL

SCREWS

PENCIL

NYLON GUIDE

RECORD MEASUREMENT D = _____________ IN

For best results use a 32-tooth hacksaw blade and

a miter box.