Installation Guide

ASSEMBLE FRAME

INSTALLATION NOTES:

710284-100 Rev. G 11/16

Screw M4x35

90˚

VIEW FROM INSIDE

This unit is best installed by two people.

Cover drain with tape prior to installation to prevent the loss of small parts.

Unpack your unit carefully and inspect for freight damage. Lay out and identify all parts using instruction sheet as a

reference. Before discarding the carton check to see that no small hardware parts have fallen to the bottom of the box. If

any parts are damaged or missing refer to the description noted in the instructions when inquiring about replacements.

Handle the glass panels carefully and protect the edges. Although tempered glass is very resistant to breakage the glass

can still break if unequal pressure is applied during installation and the sharp corners of the panel can damage tile and

ooring surface.

Be sure to wear safety glasses whenever drilling or cutting. When drilling holes in ceramic tile or marble use a center

punch and hammer to carefully break the glazed surface. This will prevent skidding when drilling.

NOTE: TEMPERED GLASS CANNOT BE DRILLED, CUT OR MODIFIED.

1A - 1C

2A - 2B

3A - 3C

Slide Bottom Guide (6) onto the bottom of

the Door Posts (18) as shown.

Attach Bottom Horizontal Rail (8) to the Door Post

with M4x35 Screws (2). Secure Bottom Guide to

Bottom Horizontal Rail with M4x10 Screws (19).

Insert Screw Cover Cap (20).

Slide Top Horizontal Rail (13) onto Door Posts

and screw together. (Refer to Assembly Drawing)

VIEW FROM TOP

1A 1B