Installation Guide

(ACTUAL SIZE)

OUTER

PANEL

ROLLER

MOUNTING

FLANGE

INNER

PANEL

ROLLER

ROLLER SCREW

BOTTOM TRACK GROOVE

BLACK “O” RING

8 X 1/2"

SHOULDER SCREW

HIGH EDGE

OF BOTTOM

TRACK

BOTTOM

TRACK

GUIDE

710006-100

Install door panels by lifting panels up and inside header

and hang rollers on each respective groove.

The outside panel with bottom track guide, fits over high

edge of bottom track. The inside panel has 4 holes at

bottom on the inside of the inside panel to attach panel

guide clips.

Slide both panels to one side. Insert two panel guide clips

into groove of bottom track.

Place the “O” ring onto #8 x 1/2" shoulder screw, then into

pre-drilled hole on inside panel. Do not over tighten

screws. Guide clips should be able to float up and

down.

Install header over each end of wall jambs.

Drill a 1/8" hole through header and into wall jamb from inside

at each end (1/4" from the wall).

Fasten header to wall jamb with screws provided.

Mount nylon rollers to slot on the top of each door.

*The nylon side of roller should be facing same way as

towel bar.

For towel bar installation see TOWEL BAR INSTALLATION

GUIDE. On Tryton doors the towel bar is already installed.