Installation Guide

QCI5297 REV. 0.1 Page 2 Cered 10/1/17
Installation Notes:
 This unit may be installed on a walls without proper blocking, including fiberglass and acrylic
walls. Proper use of the described anchors and silicone is required.
 If blocking is available for installation, DO NOT use wall inserts. Screw directly into the wood-
en blocking.
 U-Channel may be installed using wall plugs where no backing is found.
 Use caution to not pierce plumbing or electric lines while installing door hardware.
 Cover the drain with tape prior to installation to prevent loss of small parts.
 Unpack your unit carefully and inspect for freight damage. Lay out and identify all parts using
the instruction sheet as a reference. Before discarding the carton, check to see that no small
hardware parts have fallen to the bottom of the box. If any parts are damaged or missing, refer
to the description noted in the instructions when contacting your dealer for replacements.
Tools:
To install your RODA Shower Enclosure, you may need the following:
 Pencil
 Low Tack Tape
 Tape Measure
 2’, & 4’ Levels
 #2 Phillips Screwdriver
 Hack Saw
 Caulk Gun
 Clear Silicone Caulk
 Suction Cups
 7/16” shims
 Drill
 1/8”, 5/32”, 3/16”, 5/16”
Metal Drill Bits
 3/16” or 5/16” maybe required
in some installations
 Center Punch
 Files
 This unit is best installed by two people.
 Handle the glass panels carefully and protect the edges. Safety tempered glass is very re-
sistant to breakage, but the sharp corners of the panels can damage tile, flooring surfaces,
and easily damaged at the corners.
 The glass can break if unequal pressure is applied during installation.
 Please wear safety glasses whenever drilling or cutting. When drilling holes in ceramic tile or
marble, use a center punch and hammer to carefully break the glazed surface to prevent skid-
ding when drilling.
NOTE: Tempered glass cannot be
Safety Notes: