Installation Guide
QCI5297 REV. 0.1 Page 11 Cered 10/1/17
Place two 7/16” shims on the curb or threshold. These shims must remain in place throughout
the installation process. You can stack setting blocks from the Parts Pak if required.
With the help of an assistant inside the shower, lift the Door Glass Assembly into the opening and
set the panel on the shims. Slide the Adjustable Wall Jamb [3] over the Hinge Wall Jamb [2].
Work together to make the door plumb and level, adding or removing shimming from under the door
as required.
11
CL
7/16” Shim
7/16” Shim
When the door is level and plumb, check the height of the glass from the threshold.
The top of the door glass must be at least the height of the panel glass + 1/8”.
Add shims under the glass if required to raise the glass. Check and re-level and re-plumb the glass.
12