Installation Guide
QCI5297 REV. 0.1 Page 22 Cered 10/1/17
Place the Drip Vinyl onto the bottom of the door
panel. Line it up on the hinge side of the door
and cut it off flush with beginning of the Strike
Jamb.
Once adjusted to fit, run a small bead of silicone be-
tween the drip vinyl and the glass to secure the vinyl
sweep and prevent water from collecting inside the
sweep if adjusted.
32
On the interior face of the glass, place a strip of low tack tape on the glass about 1/8” to 3/16”
away from edge of the Threshold U-Channel [4] and Wall U-Channel [5]. Run a small bead
of silicone along this edge. Next, on the interior, run a bead of silicone between the u-channel
and the threshold and also between the u-channel and the wall. After completing, remove the tape
before silicone sets.
33