Installation Sheet

16 Remove the magnet and slide the vinyl partially
out of the header snap-in filler. Trim enough of the vinyl
so that the magnet is not covered by the lip of the
polycarbonate strike jamb (approximately 3/8” should
suffice). Slide the vinyl back into the filler and replace
the magnet. Place a small amount of silicone at the end
of the magnet to hold in place.
17 Fold the vinyl material [Q] over the top edge of
the glass lining it up with the magnet. Mark the two ends
of the magnet onto the vinyl with a pencil. Carefully drive
the latch [R] onto the door panel using a rubber or plastic mallet.
Close the door and check for proper operation of the latch
and magnet. (If adjustment is needed, use a rubber or
plastic mallet and a wood block and lightly tap into place).
Trim the excess vinyl off with a utility knife.
NOTE: NEVER hit the door latch with a
metal hammer!!
18 See supplement sheets for installation of the
pull handle or the pull/towel bar combination [S].
19 NOTE: The clear vinyl sweep [T] is notched
on both ends. Installation depends on the hinge side.
With the door in the open position, slide the sweep
onto the bottom of the door with the deflector lip
on the interior and the notched side under the hinge
rail [K2] of the door assembly.
20 Mark on the sweep the strike edge of
the glass with a pencil.
Remove the sweep from the door and cut the
it even with the strike edge of the glass.
INTERIOR
VIEW
EXTERIOR
VIEW
MAGNET
POLYCARBONATE
STRIKE JAMB
VINYL
HORIZONTAL VINYL
QCI5239 Rev 0 Page 9 Certified 06/20/2016