Installation Guide

5
INSTALLING BOTTOM GUIDE A
[11]
[13]
Screw ST4x25
3.2mm
5b
5c
5a
J
A
F
K
5d
5a. Carefully slide Exterior Door Panel [21] over Bottom Guide A [11] and check level of Exterior
Door Panel.
5b. Remove Bottom Guide A [11] and drill previously marked Tub Deck or Shower base using
a 3.2 mm drill bit.
5c. Place Bottom Guide A [11] back in place, up against the Aluminum Seal [19] and check that drilled holes
line up with screw hole in Bottom Guide.
5d. Using provided ST4x25 Screw [13] apply a small amount of sealant along the entire length of the
screw threads, then screw Bottom Guide A [11] into place using a Phillips Screwdriver by hand.
!
CAUTION: Do not use a power screwdriver for this step as it could damage the shower base or tub.
• In this step, you’ll need following parts: [11] x1, [13] x1
• In this step, you’ll need the following tools: A, F, I, J, K