Installation Guide

POST INSTALLATION CLEAN-UP
Remove all construction debris from bath. Tile grout can be removed with a wooden popsicle stick
or tongue depressor.
Do not use wire brushes or any other metal implement on bath surface. Post installation clean-up generally
can be completed using warm water and liquid dishwashing detergent. Stubborn dirt or stains may be
removed using granular Spic and Span
®
mixed with water.
Painter’s naphtha can be used to remove excess adhesives and/or wet oil-base paint.
AFTERCARE AND CLEANING
Two primary materials are used to manufacture your new American Standard shower enclosure: tempered glass
and anodized aluminum. To assure a long lasting nish on the enclosure, wipe it down with a towel after each
use.
For occasional, more concentrated cleaning efforts Lysol Non-Abrasive Bathroom Cleaner works extremely well.
Be sure that any over spray falling on the aluminum frame is rinsed thoroughly and dried. Many over-the-counter
cleaners, if applied to the aluminum and left on, will harm the metal nish and cause permanent damage even
though their directions indicate safe use on shower doors. Never use a scouring agent to clean the aluminum.
Spic And Span® Is A Registered Trademark Of The Spic And Span Company