Installation Guide

Image shown may vary from product purchased.
OWNERS MANUAL
Ovation Curve
Alcove Shower Doors
AM00843400 / AM00844400 / AM00845400
INSTALLATION INSTRUCTIONS
Thank you for selecting American Standard – the benchmark of ne quality for over 150 years. To ensure this
product is installed properly, please read these instructions carefully before you begin. Certain installations may
require professional help. Also be sure your installation conforms to local codes.
INSTALLATION PREPARATION
Please unpack carefully and identify all parts needed for installation by using the Box Contents page as a
reference. Inspect the product and report any damages or missing parts immediately to customer care by
calling 800-442-1902. Follow the prompts for consumer/shower doors.
The Ovation Curve Shower Doors were developed to be installed with the Ovation Curve Shower Bases
and Tub, and the Ovation Curve Shower Walls. If you are using a different base, tub or walls, you may need
additional hardware and tools to complete the installation.
The Ovation Curve shower door dimensions are nominal and meant for a standard 60" (1524 mm) and
48" (1219 mm) alcove. Alcove sizes may vary based on stud and wall material thickness.
Please double check your measurements prior to starting your install.
Range opening of a 60" (1524mm) door on a nished wall is 58-1/16" (1475mm) to 58-7/16" (1485mm).
Range opening of a 48" (1219mm) door on a nished wall is 46-1/8" (1171mm) to 46-1/2" (1181mm).
Handle the glass panels carefully and protect the edges. Unequal pressure applied during installation can
cause cracking or breakage, and the sharp corners on the glass panels can cause damage to the wall or
oor materials.
• Ensure adequate wall support is provided to area where shower door is to be installed.
• Shower base and wall material must be installed prior to the door installation.
• Wear protective equipment during installation to avoid injury.
• Please keep these instructions for after care and customer service details.
!
WARNING: PRODUCT IS HEAVY AND REQUIRES TWO PEOPLE FOR INSTALLATION.
!
WARNING: TEMPERED GLASS CANNOT BE DRILLED, CUT OR MODIFIED.