Installation Guide

6
ADJUSTING DOOR PANEL-L
• In this step, you’ll need following part: [15] x1
6a. Slide Door Panel-L [10] closed and observe if the door securely seals against both Magnetic Seals [8] & [7]
equally. If a gap exists at either end of Door Panel-L [10] it will be necessary to adjust the Exterior
Wheels [13] to correctly fit the Door Panel to the Magnetic Seals. Remove the cover cap from the
Exterior Wheel [13] to expose the door adjustment nut. Using the supplied Wrench [16], turn the
hex nut on the Exterior Wheel left or right to move the door up or down on that side.
6b. Remove the cover cap on the opposite Exterior Wheel [13] and use the supplied Wrench [16] to adjust
the door up or down if adjustment is required on that side.
6c. Close Door Panel-L [10] and ensure it seals against both Magnetic Seals [7] & [8] evenly.
Place cover caps back on Exterior Wheels.
[13]
[13]
Cover Cap
Correct Door
Alignment
[16]
6a 6b 6c
Cover Cap
Allow 24 hours for silicone to dry before use.
A
• In this step, you’ll need the following tool: A
7a. Apply silicone at all outside locations as shown.
Allow 24 hours for silicone to dry before use.
7
APPLYING SILICONE SEALANT