Installation Guide

Table Of Contents

INSTALLATION INSTRUCTIONS

• In this step, you’ll need following parts: [3] x2, [24] x6, [25] x6, [26] x6, [27] x6

• In this step, you’ll need the following tools: B, C, D, G, I, J

1a. From outside edge of shower base threshold, measure 1-3/16" (30.2mm) and mark deck of base with

Pencil [I]. Place Wall Post [3] onto mark on deck of base and plumb. Tape Wall Post [3] to wall to

temporarily hold wall post in place.

1b. Mark each predrilled hole in Wall Post [3] with a pencil and remove Wall Post [3]. Repeat on opposite side.

1c. If using supplied Wall Anchors [24] drill each of the marks on the wall from step 1b using a 6mm drill bit.

If not using Wall Anchors, drill using appropriate size bit for screw being used.

1d. If using Wall Anchors [24], place into each drilled hole.

1e. Place either Left or Right Wall Post [3] on the wall, and place a Back Screw Cap [27] over each ST4x35

screw [25] and screw Wall Post [3] into place.

1f. Cover each ST4x35 screw head [25] using Screw Caps [26].

PREPARING INSTALLATION OF WALL POSTS

IMPORTANT GENERAL INFORMATION

This unit is best installed by two people.

Cover drain with tape prior to installation to prevent the loss of small parts.

Unpack your unit carefully and inspect for freight damage. Lay out and identify all parts using Box

Contents and Assembly Drawing as a reference. Before discarding the carton check to see that no

small hardware parts have fallen to the bottom of the box. If any parts are damaged or missing refer to

the description noted in the instructions when inquiring about replacements.

Handle the glass panels carefully and protect the edges. Although tempered glass is very resistant to

breakage, the glass can still break if unequal pressure is applied during installation and the sharp corners

of the panel can damage tile and ﬂooring surface.

Be sure to wear safety glasses whenever drilling or cutting. When drilling holes in ceramic tile or marble

use a center punch and hammer to carefully break the glazed surface. This will prevent skidding

when drilling.

NOTE: TEMPERED GLASS CANNOT BE DRILLED, CUT OR MODIFIED.

[3]

Screw

ST4x35

6mm

Shower

Base

Outside of

Threshold

Locate Wall Post From Outside of Threshold

[24]

[27]

[26]

[25]

1a 1d

[3]