Other

- 1 -

Product names listed herein are trademarks of AS America, Inc.

Thank you for selecting American Standard...

the benchmark of ne quality for over 140 years.

To ensure that your installation proceeds smoothly-please read

these instructions carefully before you begin.

RECOMMENDED TOOLS

INSTALL FAUCET

Delancey

Single Lever Lavatory Faucet

With Push Drain

INSTALLATION

INSTRUCTIONS

7052107

7052114

Screwdriver Adjustable WrenchChannel Locks

Certied to comply with ANSI A112.18.1M

CAUTION

Turn off hot and cold water

supplies before begining.

MOUNTING

SURFACE

M965983 (9/18)

• Seat SEAL (1) into under side of FAUCET BASE (2).

• Feed FAUCET SUPPLIES (3) and MOUNTING SHANK (4)

through hole in mounting surface.

• From below, install GASKET (5) and MOUNTING NUT (6) onto

SHANK (4). Secure Faucet with MOUNTING NUT (6).

Before nal tightening, adjust Faucet so that it is centered.

Tighten MOUNTING NUT (6) to complete mounting.

HOT LINE FOR HELP

For toll-free information and answers to your questions, call:

1 (800) 442-1902

Mon. - Fri. 8:00 a.m. to 8:00 p.m. EST

Saturday 10:00 a.m. to 4:00 p.m. EST

IN CANADA 1-800-387-0369

(TORONTO 1-905-306-1093)

Weekdays 8:00 a.m. to 7:00 p.m. EST

IN MEXICO 01-800-839-1200

PAGE 1
INSTALLATION INSTRUCTIONS Delancey® 7052107 7052114 Single Lever Lavatory Faucet With Push Drain Thank you for selecting American Standard... the benchmark of fine quality for over 140 years. To ensure that your installation proceeds smoothly-please read these instructions carefully before you begin. Certified to comply with ANSI A112.18.1M RECOMMENDED TOOLS Screwdriver 1 INSTALL FAUCET CAUTION Channel Locks Adjustable Wrench Turn off hot and cold water supplies before begining.
PAGE 2
INSTALL DRAIN FROM BELOW FIXTURE 3 REAR OF SINK DRAIN OUTLET 1 2 3 1 2 • Thread TAIL PIECE NUT (1) clockwise onto DRAIN BODY (2). • Install DRAIN (1) by dropping it from the top of the sink. • From under side of SINK install GASKET (2) and MOUNTING NUT (3). Note: Plumber’s putty or caulk is recommended. 4 FLANGE GASKET AND POP-UP KNOB FOAM GASKET NOT VISIBLE 5 CHECK OPERATION OF POP-UP 1 DRAIN FLANGE • Operate DRAIN STOPPER (1) to verify that it opens and closes.
PAGE 3
7 TEST INSTALLED FITTING ON OFF COLD • With HANDLE (1) in OFF position, turn on WATER SUPPLIES (2) and check all connections for leaks. HOT 1 • Remove AERATOR (3). • Operate HANDLE (1) to flush water lines thoroughly. • Replace AERATOR (3). 3 CHECK DRAIN CONNECTIONS • Fill lavatory with water. Check that DRAIN STOPPER (4) makes a good seal and retains water in SINK. • Release DRAIN STOPPER (4) down and check all drain connections and “P” trap for leaks. Tighten if necessary.