Installation & Assembly

M968986 Rev. 1.4

SINGLE CONTROL

KITCHEN PULL-OUT FAUCET

4175.100

Thank you for selecting American-Standard...

the benchmark of ﬁne quality for over 100 years.

To ensure that your installation proceeds smoothly--

please read these instructions carefully before you begin.

Installation

Instructions

Certiﬁed to comply with ANSI A112.18.1M

INSTALL FAUCET WITH OR WITHOUT DECK ESCUTCHEON

PUTTY

SPOUT BASE

SINK OR

MOUNTING

SURFACE

Assemble RUBBER WASHER (4), BRASS WASHER (5), and threaded LOCKNUT (6) onto SHANK (3) from underside

of sink or mounting surface. Hand tighten LOCKNUT (6) and check that rotation of HANDLE (7) from HOT to COLD

is centered.

Use a screwdriver to tighten SCREWS (8) on LOCKNUT (6). Work your way around LOCKNUT (6), tightening

the screws slightly each time until all are snug to ensure even pressure.

(A) Installation with ESCUTCHEON (1). Apply a bead of putty to bottom edge of ESCUTCHEON with PUTTY PLATE (1).

Insert supply HOSES (2) and SHANK (3) through hole of ESCUTCHEON with PUTTY PLATE (1) and mounting surface.

Follow mounting instructions below to secure faucet to mounting surface.

(B) Installation less ESCUTCHEON (1). Discard ESCUTCHEON with PUTTY PLATE (1). Insert supply HOSES (2) and

SHANK (3) through mounting hole and seat SPOUT BASE onto sink or mounting surface. Do not use putty.

Plumbers' Putty or Caulking

Adjustable Wrench

Phillips Screwdriver

RECOMMENDED TOOLS

Regular Screwdriver

Insert HOSES (2) through RUBBER WASHER (4), BRASS WASHER (5), and threaded LOCKNUT (6).

Turn off water at

main supply.

CAUTION

COLONY SOFT

PAGE 1
Installation Instructions 4175.100 COLONY SOFT SINGLE CONTROL KITCHEN PULL-OUT FAUCET Thank you for selecting American-Standard... the benchmark of fine quality for over 100 years. To ensure that your installation proceeds smoothly-please read these instructions carefully before you begin. Certified to comply with ANSI A112.18.1M M 9 6 8 9 8 6 R ev. 1.
PAGE 2
MAKE WATER SUPPLY CONNECTIONS Turn off hot and cold water supplies before beginning. Connect FLEXIBLE SUPPLIES (1, 2) directly to wall supplies. Connection on fitting supplies are 3/8" compression. Connect left supply (Marked with a Red Stripe) to Hot and right supply (Marked with Blue Stripe) to Cold wall supply. Use adjustable wrench to tighten connections. Do not over tighten. 2 1 Faucet supplies are 21" long from faucet base.
PAGE 3
5 CHECK CONNECTIONS FOR LEAKS. Move HANDLE down into "off" position. Turn on water supplies and check connections for leaks. Operate HANDLE (2) up and down, left and right to flush water lines thoroughly. Operate HAND SPRAY and check connections for leaks. CHECK CONNECTIONS FOR LEAKS 6 SERVICE If faucet drips, operate HANDLE several times from "off" to "on." Do not apply excessive force. FLOW CONTROL DEVICE may accumulate dirt.