Bath/Shower Trim Kits Installation Instruction

ManualsBrandsAmerican Standard ManualsIndoor FurnishingBath/Shower Trim Kits T373.500

ENFIELD

FINISHED WALL

BOTTOM OF TUB

74" FOR HEAD

CLEARANCE

5-1/8" REF.

7-7/8" REF.

18" OPTIONAL

5-3/4" REF.

1/2" NPT

9-1/8"

1-1/2” REF.

OPTIONAL TO FINISHED

FLOOR USUALLY

BETWEEN 65'' AND 80''

1-1/2” REF.

TOP OF TUB RIM

M968285 Rev. 1.1

T373.502 T373.522

T373.501 T373.521

T373.500 T373.520

Installation

Instructions

Certified to comply with ANSI A112.18.1

BATH/SHOWER

TRIM KITS

with EverClean™ Finish

Congratulations on purchasing your American Standard faucet with

EverClean finish found only on American Standard faucets.

To ensure that your installation proceeds smoothly-please read these instructions carefully before you begin.

Required Tools

Adjustable Wrench

Channel Locks

Flat Blade Screwdriver

Plumbers' Putty or Caulking

Phillips Screwdriver

ROUGHING-IN DIMENSIONS

Installation for Bath/Shower, Shower only, or

Valve only Trim.

O Dimensions are for reference.

EverClean Finish

• One wipe effortlessly removes spots

• Eliminates the need for cleaners and scrubbing

• Permanent surface protectant remains beautiful

for the life of the faucet

• EverClean™ available on: Polished Chrome, Satin Nickel,

Stainless Steel, Polished Brass (or any combination of these finishes)

Summary of content (3 pages)

PAGE 1
Installation Instructions ENFIELD BATH/SHOWER TRIM KITS with EverClean™ Finish T373.502 T373.501 T373.500 T373.522 T373.521 T373.520 Congratulations on purchasing your American Standard faucet with EverClean finish found only on American Standard faucets.
PAGE 2
1 INSTALL TRIM CAUTION: Protect finish on SHOWER ARM, SHOWER HEAD and TUB SPOUT when installing. When finished tiling the wall, remove PLASTER GUARD (A) and turn off water supply. Install STEM ADAPTER (1) onto valve stem with ADAPTER SCREW (2). Push CAP (3) over VALVE CARTRIDGE (4). Mount ESCUTCHEON (5) to valve body with SCREWS (6). Push DIAL PLATE (7) over CAP (3) and into the four alignment holes in ESCUTCHEON (5). Remove PIPE CAP (8) and PIPE CAP (9) from shower pipe and tub filler pipe.
PAGE 3
BACK TO BACK INSTALLATION Remove PRESSURE BALANCE UNIT (5). Rotate PRESSURE BALANCE UNIT (5) 180˚ so that the inlets face up and the large outlet port faces down. Push PRESSURE BALANCE UNIT (5) in casting make sure inlets line up with holes in bottom of casting. Top flange should butt up against top of casting. Reassemble FIXATION RING (4) and CARTRIDGE (1).