Specification

710285-100 Rev. E

VIEW FROM INSIDE

The Sliding Glass Door Panel (7) may be

placed on either the left-hand side or

right-hand side of the assembled frame.

INSTALLING FIXED GLASS PANEL

LOCATING SLIDING GLASS DOOR PANEL

It is recommended that the Sliding Glass

Door Panel is installed on the same side of

the shower enclosure as the shower head. This

will allow the water temperature to be adjusted

prior to entering the shower enclosure.

The following instructions (1A-1C), illustrate the

installation of the Sliding Glass Door Panel on the

left side of the shower enclosure. If desired, you may

install the Sliding Glass Door Panel on the right side

of the shower enclosure (2A).

Please ensure that the attachment hardware & the

Handle Sets (4) are in the correct locations (2B-2C).

ScrewM4x16

(Shown from Underside of Bottom Rail)

Place bottom of Fixed Glass Panel (17) into Center Guide (9) and slide into

Bottom Guide until it is seated in the Door Post (18).

Insert Glass Bracket Cover (15) into the Glass Bracket (14). Slide Glass Bracket

so that it is aligned with the hole closest to the end of the Fixed Glass Panel.

Secure Glass Bracket to the Horizontal Rail with M4x16 Screw (16). Insert Gray

Cover Cap (22) into the unused hole on the Top Horizontal Rail.

1A-1B

2A-2B

3A-3B

SLIDING GLASS PANEL INSTALLED ON LEFT

SLIDING GLASS PANEL INSTALLED ON RIGHT