Instructions / Assembly

754964-100 Rev. A

A) Apply a bead of tub surround adhesive down each stud

that will come in contact with the back panel being sure

to stay below the line you marked. You do not need to

apply adhesive to the corner studs.

B) Lay a bead of sealant along the inside corner of the

shower base ledge as shown in Fig. 2.

C) Reposition back panel aligned with pencil line and press

firmly against studs.

Stud

Drill clearance hole

for screw in top

nailing flange

Drill clearance hole

for screw in front

nailing flange

Mating surface

(square and plum)

Fig. 3

A) • Locate and drill a clearance hole in the center of the top nailing flange and centered on each stud (see arrows as shown).

• Also drill four evenly spaced clearance holes on the front nailing flange on each side (see arrows as shown).

B) Ensuring mating surface is square and plum (Fig. 3), install galvanized screws through each clearance hole

and into the studs, securing the wall panel.

C) Add a bead of sealant down the vertical corner of the back panel (Fig. 3).

1 x 4

Fig. 2

WALL

NAILING

FLANGE

TILE

FLANGE

SEALANT

DRILL CLEARANCE

HOLES FOR SCREW

Pencil line

SEALANT

TUB SURROUND

ADHESIVE BEAD