Specifier Elongated Toilet Specification Sheet

ManualsBrandsAmerican Standard ManualsIndoor FurnishingCadet 4392.800SMT

CADET™ SPECIFIER

ELONGATED TOILET

VITREOUS CHINA

CADET™ SPECIFIER ELONGATED TOILET

❏ 2883.012

• Vitreous china

• Low-consumption (6.0 Lpf/1.6 gpf)

• Elongated siphon action jetted bowl

• Fully glazed 2” Ballpass trapway

• Fluidmaster Fill Valve

• Large 11” x 9” water surface area

• Close-coupled tank

• Color-matched trip lever

• Sanitary bar on bowl

• 2 bolt caps

• 100% factory flush tested

❏ 3459.016 Bowl

❏ 4392.001SMT Tank

Nominal Dimensions:

749 x 508 x 737mm

(29-1/2" x 20" x 28-3/4")

Fixture only, seat and supply by others

Alternate Tank Configurations Available:

❏ 4392.800SMT Tank complete with

Trip Lever Located on Right Side

To Be Specified

❏ Color:

❏ Seat: American Standard #5324.019 "Rise and

Shine" (with easy to clean lift-off hinge system)

solid plastic closed front seat with cover.

See pageTB-001.

❏ Seat: American Standard #5311.012 "Laurel"

molded closed front seat with cover.

See pageTB-001.

❏ Alternate Seat:

❏ Supply with stop:

Revised 5/04

305mm

(12)

749mm

(29-1/2)

C/L OF OUTLET

76mm

(3-1/4)

FINISHED WALL

232mm

(9-1/8)

25mm ± 6mm

(1 ± 1/4)

381mm

(15)

470mm

(18-1/2)

C/L

C/L OF SEAT POST HOLES

140mm (5-1/2 CENTERS)

305mm

(12)

178mm

(7)

16mm

(5/8)

FINISHED

FLOOR

730mm

(28-3/4)

241mm

(9-1/2)

146mm

(5-3/4)

508mm

(20)

222mm

(8-3/4)

SUPPLY

REQ'D

381mm

(15)

NOTES:

THIS COMBINATION IS DESIGNED TO ROUGH-IN AT A MINIMUM DIMENSION OF 305MM

(12") FROM FINISHED WALL TO C/L OF OUTLET.

DIMENSION SHOWN FOR LOCATION OF SUPPLY IS SUGGESTED.

SUPPLY NOT INCLUDED WITH FIXTURE AND MUST BE ORDERED SEPARATELY.

IMPORTANT: Dimensions of fixtures are nominal and may vary within the range of tolerance

established by ANSI Standard A112.19.2

These measurements are subject to change or cancellation. No responsibility is assumed for use

of superseded or voided pages.

Compliance Certifications -

Meets or Exceeds the Following Specifications:

• ASME A112.19.2M (and 19.6M) for Vitreous

China Fixtures - includes Flush Performance,

Ball Pass Diameter, Trap Seal Depth and

all Dimensions