Single Control Kitchen Faucet Installation Instructions

SINGLE CONTROL KITCHEN

FAUCET AND PULL OUT SPRAY

Installation

Instructions

.3&7

Certiﬁed to comply with ANSI A112.18.1M

4147.100

Culinaire



CAUTION



INSTALL FITTING WITH OR WITHOUT DECK ESCUTCHEON

Turn off hot and cold water

supplies before beginning.

PUTTY

Plumbers' Putty or Caulking

Adjustable Wrench

Phillips Screwdriver

Channel Locks

TOOLS REQUIRED

Insert supply HOSES (3) and SHANK (4) through center hole of ESCUTCHEON (1)

(if used) sink or mounting surface.

Make certain the large SEAL (2) is properly seated in recess of faucet body.

Use a screwdriver to tighten the SCREWS (9) on LOCKNUT (7). Work your way

around LOCKNUT (7), tightening the screws slightly each time until all are snug to

ensure even pressure.

Apply a bead of putty to bottom edge of ESCUTCHEON (1). Note: Installation of

ESCUTCHEON (1) is optional.

Assemble RUBBER WASHER (5), BRASS WASHER (6), and threaded LOCKNUT (7)

onto SHANK (4) from underside of sink. Hand tighten LOCKNUT (7) and check that

faucet is centered.

NOTE: FAUCET CAN BE INSTALLED FOR RIGHT OR LEFT HAND APPLICATIONS.

LH RH

5VCJOH$VUUFS

Congratulations on purchasing your American Standard faucet with

EverClean nish found only on American Standard faucets.

EverClean Finish

• One wipe eortlessly removes spots

• Eliminates the need for cleaners and scrubbing

• Permanent surface protectant remains beautiful for the life of the faucet

• EverClean™ available on: Polished Chrome, Satin Nickel, Stainless Steel, Polished Brass (or any combination of these nishes)

To ensure that your installation proceeds smoothly-please read these instructions carefully before you begin.

with EverClean™ Finish

PAGE 1
Culinaire Installation Instructions 4147.100 SINGLE CONTROL KITCHEN FAUCET AND PULL OUT SPRAY with EverClean™ Finish Congratulations on purchasing your American Standard faucet with EverClean finish found only on American Standard faucets. Certified to comply with ANSI A112.18.1M EverClean Finish • One wipe effortlessly removes spots • Eliminates the need for cleaners and scrubbing • Permanent surface protectant remains beautiful for the life of the faucet .
PAGE 2
MAKE WATER SUPPLY CONNECTIONS Turn off hot and cold water supplies before beginning. Connect FLEXIBLE SUPPLIES (1, 2) directly to wall supplies. Connection on fitting supplies are 3/8" compression. Connect left supply (Marked with a Red Stripe) to Hot and right supply (Marked with Blue Stripe) to Cold wall supply. Use adjustable wrench to tighten connections. Do not over tighten. BLUE STRIPE RED STRIPE Faucet supplies are 24" long from faucet base.
PAGE 3
TEST INSTALLED FAUCET Move HANDLE (1) into "off" position and remove AERATOR (2). 3 Turn on water supplies and check connections for leaks. 2 Operate HANDLE (1) on and off, hot and cold to flush water lines thoroughly. 1 Pull SPRAY (3) out and activate. Check hose and supply connections for leaks. Move HANDLE (1) to "off" position and replace SPRAY (3) and AERATOR (2). CHECK FOR LEAKS SERVICE Reduced flow.