Countertop Sink Specification Sheet

J34
BARRIER FREE
© 2008 AS America Inc.
FINISHED
WALL
OR
SPLASH BACK
COUNTERTOP
CUTOUT 384mm
(15-1/8) DIA.
206mm
(8-1/8)
419mm
(16-1/2)
38mm
(1-1/2)
MIN.
51mm
(2)
MIN.
B
A
C/L
1-1/4 O.D.
TAILPIECE
1-1/4 O.D.
WASTE
203mm
(8)
159mm
(6-1/4)
178mm
(7)
29mm
(1-1/8)
COUNTERTOP
(BY OTHERS)
SEALING
COMPOUND
SUPPLIES
AS REQ'D.
305mm
(12)
*
254mm
(10)
*
FINISHED
FLOOR
787mm
(31)
SUGGESTED
835mm
(32-7/8)
FAUCET
CENTER-SET
SPREAD
A
27mm(1-1/16)
32mm(1-1/4)
B
102mm(4)
203mm(8)
L
of Faucet **
C
848mm
(33-3/8)
51mm
(2)
610mm
(24)
152mm
(6)
MAX.
BARRIER FREE
CLEARANCE
686mm
(27)
MIN.
203mm
(8)
MIN.
229mm
(9)
MIN.
DRAWING FOR
DIMENSIONAL
PURPOSES ONLY.
IT IS NOT AN EXACT
REPRESENTATION.
ENFIELD™ COUNTERTOP SINK
• Decorative ogee rim detail round sink
• Made from vitreous china
• Self-rimming with cutout template supplied
• Center drain outlet
• Front overow
❏ 0740.000 Round Sink less Faucet Deck
Nominal Dimensions:
419mm (16-1/2") Round
Bowl Sizes:
324mm (12-3/4") round
152mm (6") deep
Compliance Certications -
Meets or Exceeds the
Following Specications:
• ASME A112.19.2M for
Vitreous China Fixture
ENFIELD™
COUNTERTOP SINK
VITREOUS CHINA
To Be Specied:
❏ Color: ❏ White ❏ Bone
❏ Linen ❏ Black
❏ Faucet*:
❏ Faucet Finish:
❏ Supplies:
❏ 1-1/4" Trap:
* See faucet section for additional models available
MEETS THE AMERICANS WITH DISABILITIES ACT GUIDELINES
AND ANSI A117.1 ACCESSIBLE AND USABLE
BUILDINGS AND FACILITIES - CHECK LOCAL CODES.
Install lavatory 864mm (34") from finished floor.
Lavatory installed 51mm (2") minimum from front edge
of countertop provides 686mm (27") knee clearance area.
Revised 2/08
NOTES:
*
DIMENSIONS SHOWN FOR LOCATION OF SUPPLIES AND “P" TRAP
ARE SUGGESTED.
**
SPOUT MUST BE 4-5/8" LONG (min.) FOR ADEQUATE CLEARANCE
INTO SINK
FITTINGS NOT INCLUDED WITH FIXTURE AND MUST BE ORDERED
SEPARATELY.
FOR COUNTERTOP CUTOUT AND INSTALLATION INSTRUCTIONS USE
TEMPLATE SUPPLIED WITH SINK.
IN-FIELD ADJUSTMENT OF POP-UP ROD EXTENSION REQUIRED.
PROVIDE A 2-1/2"
SEALING COMPOUND SUPPLIED BY OTHERS.
IMPORTANT: Dimensions of xtures are nominal and may vary within the
range of tolerances established by ANSI Standard A112.19.2 These
measurements are subject to change or cancellation. No responsibility is
assumed for use of superseded or voided leaet.
Shown with Hampton 8" Faucet (7881732.295)