Enfield Two-Piece Toilet Installation Instructions

730498-100
6
10
7
INSTALL TOILET
a. Position toilet squarely to wall and, with a
rocking motion, press bowl down fully on wax
ring and flange. Alternately tighten nuts until
toilet is firmly seated on floor.
CAUTION:
DO NOT OVERTIGHTEN NUTS
OR BASE MAY BE DAMAGED!
b. Install caps on washers. (If necessary, cut bolt
height to size before installing caps.)
c. Smooth off the bead of sealant around base.
Remove excess sealant.
INSTALL TANK
a. Install large rubber gasket over
threaded outlet on bottom of tank
and lower tank onto bowl so that
tapered end of gasket fits evenly into
bowl water inlet opening.
b. Insert tank mounting bolts and
rubber washers from inside tank,
through mounting holes, and secure
with metal washers and nuts.
c. With tank parallel to wall, alternately
tighten nuts until tank is snugged
down evenly against bowl surface.
INSTALL TOILET SEAT Install toilet seat in
accordance with manufacturer's directions.
CLOSET FLANGE
CLOSET BOLT
NUT
WASHER
BOLT CAP
RUBBER
GASKET
TANK MTG.
BOLTS
BLACK
VAPOR
BARRIER
WOOD
TRIM
COVER
NUT
WASHER
!
- 2 -
!
CAUTION:
DO NOT OVERTIGHTEN NUTS MORE
THAN REQUIRED FOR A SNUG FIT!
RUBBER
WASHER
11a
Before continuing, determine the type of water supply connecation you
have from the chart below and use the appropriate assembly parts
required to properly reconnect the water supply. DO NOT use plumber's
putty to seal these fittings.
CAUTION: DO NOT USE
CONE WASHER WITH
PLASTIC SUPPLY LINE.
These parts must be used as
illustrated to insure water-tight
connection. Use of existing
coupling nut may result in
water leakage. Water supply
tube or pipe must extend at
least 1/2" inside threaded
shank of valve (does not apply
to flanged tubing).
Use existing
coupling nut
and washer.
Use existing spiral
cone washer.
Fluidmaster cone
washer may not
seal completely on
spiral type supply
line.
Captive cone
washers already
included. No
additional washers
needed.
CAUTION: Overtightening of
LOCK NUT or COUPLING NUT
could result in breakage and
potential flooding.
METAL/COPPER
FLARED TUBING
METAL FLANGED
TUBING
METAL SPIRAL
TUBING
VINYL/BRAIDED
CONNECTOR
LOCK NUTLOCK NUT LOCK NUT LOCK NUT
COUPLING
NUT
COUPLING
NUT
EXISTING
COUPLING
NUT
COUPLING
NUT
WATER
SHUT-OFF
WATER
SHUT-OFF
WATER
SHUT-OFF
WATER
SHUT-OFF
CONE
WASHER
EXISTING
CONE
WASHER
EXISTING
WASHER
8
9
INSTALLATION
Place wood trim with hook and
loop strips on tank rim, vapor
barrier side down. Hand press in
place. Insert pull handle rod into
escutcheon on tank cover. Place
tank cover on to wood trim. Tip
wood trim with cover rear ward to
allow hand access into tank and
install hook on flapper bead chain
to end hole (lower) in pull handle.
Place lid in place.
INSTALLING TANK COVER
(with wood trim) 9860.000
INSTALLING TANK COVER (without wood trim)
Insert pull handle rod into escutcheon on tank cover.
Place tank cover on tank, tip cover rear ward to allow
for hand access into tank and install hook
on flapper bead chain into second hole (upper) in pull
handle rod.
Place lid in place.