Specification Sheet

FEATURES
NOTES
CR/PL© 11/02 Printed in U.S.A.
* Not furnished by Fiat Products. Description for specification purposes only.
OPTIONS
FIAT PRODUCTS
A CRANE PLUMBING COMP ANY
¤
• Model L-7 has an overall outside dimensions of
24" x 20" x 13
3
/8", and inside compartment dimensions of
20
1
/8" x 17
3
/4" x 11
5
/8".
• Model FL-7 has an overall outside dimensions of
24" x 20" x 13
3
/8", and inside compartment dimensions of
20
1
/8" x 17
3
/4" x 11
5
/8".
M OLDED-STONE
®
LAUNDRY TUBS
L-7 / FL-7
• L-7 Wall Hung Serv-A-Sink
®
Model L-7 Single Tub is furnished with and
supported by a mounting bracket of heavy
gauge galvanized steel capable of being
secured to the wall with mechanical fasteners.
Model L-7 side fillers and bottom tub support,
which are assembled in the field to the mounting
bracket are made of white molded plastic
polymer. Model L-7 has an integral drain and is
available in 4" or 8" knockout center which are
field drilled.
• FL-7 Floor Mounted Serv-A-Sink
®
FL-7 Single Tub is furnished with and supported
by white baked enamel steel angle legs that slip
into molded retainers and/or sockets for rigid
friction fit. Legs are supplied with leveling
devices. Model FL-7 has an integral drain and
is available in 4" or 8" knockout centers which
are field drilled.
Molded-Stone
®
Serv-A-Sink
®
Single Compartment Laundry Tubs
• Deck type faucet (4" center set) with 6
3
/4" spout. (A-1)
• Overflow pipe with "O" ring to fit 1
1
/2" strainer. (A-2)
• Polypropylene faucet block, 5
1
/8" x 1
1
/2" x 1
1
/4" for installing
clamp-on or integral clamp faucets to deck to accept over
head water supplies. (A-3)
• Faucet for top supplies. Clamps on with swing spout and
angled nose end. (A-17)
• Deck type faucet (8"center set) with spout. (A-18)