Operating instructions

ManualsBrandsAmerican Standard ManualsAir CleanerIFD AIR CLEANER

Pub. No. 18-HE56D1-9 19

Installer's Guide

CELL CLEANING SETTING (Figure 43)

One or more of the YELLOW LED’s will come on indicating

the COLLECTION CELL cleaning time setting. Repeatedly

press the RESET button to cycle through the time options for

the COLLECTION CELLS cleaning cycle until the desired

setting is displayed. Press the POWER button once to

accept that setting and move to the power settings.

2 Month 4 Months 6 Months* 9 Months

CLEAN

DIRTY

CLEAN

DIRTY

CLEAN

DIRTY

CLEAN

DIRTY

Figure 43 Yellow LED COLLECTION CELL Settings

*Factory Setting

FIELD CHARGER POWER LEVEL

The RED LED lights are used to set the power level of the

FIELD CHARGER for maximum, medium, or minimum. The

number of illuminated RED LED lights indicates the current

setting. The factory setting is for maximum.

Lower settings will reduce the slight sound emitted by the

unit with minimal loss of air cleaning efficiency, if desired.

Lower settings will also further reduce the very low ozone

produced by the air cleaner. The U.S. Food and Drug

Administration recommends indoor ozone concentrations

should not exceed 50 parts per billion. Your air cleaner will

contribute only 5 parts per billion at the factory setting and

can be reduced to 3 parts per billion at the minimum setting.

FIELD CHARGER POWER LEVEL

SETTINGS (Figure 44)

One or more of the RED LED lights will illuminate. To

change the Power Level setting, press the RESET button

until the desired setting is indicated.

To save your new settings and exit the Set-Up mode, press

and hold BOTH the POWER and filter RESET buttons for a

minimum of 5 seconds.

Minimum Medium Maximum*

CLEAN

DIRTY

CLEAN

DIRTY

CLEAN

DIRTY

Figure 44 Red LED Power Level Settings

*Factory Setting

H. MAINTENANCE

▲

CAUTION

Before cleaning the coil or ducts in the air handler or

furnace, remove the COLLECTION CELLS, FIELD

CHARGER, and PRE-FILTER from the air cleaner.

Chemicals used during the cleaning of the air

handler, furnace, or ductwork can damage the air

cleaner components and degrade the performance of

the air cleaner.

For maximum efficiency, the COLLECTION CELLS and

PRE-FILTER should be inspected and cleaned as

prescribed in this Installer's Guide.

The FIELD CHARGER should only be removed and

cleaned annually by a qualified service professional.

CLEANING

Cleaning Instructions:

The air cleaner utilizes a PRE-FILTER and

COLLECTION CELLS. The purpose of the PRE-FILTER

is to capture large particles before they enter the

COLLECTION CELLS which allows the COLLECTION

CELLS to work more efficiently.

1. Turn the air conditioning system off at the Comfort

Control (thermostat).

▲

WARNING

High Voltage is present within the air cleaner for

operation. Before removing the Power Door, turn the

power off and wait at least 15 seconds to allow

voltage to discharge. Failure to follow instructions

could result in death or serious personal injury.

2. Turn off power to the air cleaner by pushing and

holding the POWER button for three seconds. The

LED’s will remain on until the voltage has discharged

and it is safe to remove the door. This requires ap-

proximately 15 seconds. Do not remove the door

until all the lights are off.

3. Disconnect the power/control cable.

4. Rotate the two latches and remove the door as shown

in Figure 45. Place the door in a secure location.

Figure 45 Rotating Door Latches

Rotate Latches