System information

EAC-SF-13 Numbers in [brackets] are for 50 Hz international systems. 17
Service Facts
5. Press the POWER button to turn on the Air Cleaner.
NOTE: Once you press the POWER button, the first LED
will be on and it will start flashing after the first 10 [12]
minutes of indoor fan operation. This is normal
operation.
Plug Power Cord
in here
Power Button
Amber Light
Handles Fold
Flat
3. Replace the power door onto the Air Cleaner.
4. Ensure the power cord is plugged into the Air Cleaner.
Carefully review BOTH of the COLLECTION CELLS for the
“200/200-1” mark. If the “200/200-1” mark is visible on
BOTH COLLECTION CELLS, they may be washed. If the
“200/200-1” mark is NOT visible, the COLLECTION CELLS
cannot be washed.
NOTE: The PRE-FILTER may also be washed ONLY if the
COLLECTION CELLS show a "200/200-1". Follow the
same instructions to wash the PRE-FILTER - being sure
to tap gently and wipe off any visible water droplets.
Washing COLLECTION CELLS that do NOT have the “200/
200-1” mark on them can result in degradation of the Air
Cleaner system. Failure to follow this instruction could
result in property damages.
1. If the COLLECTION CELLS do have the “200/200-1” mark
on them, they may be washed using a low pressure water
spray, such as a sink sprayer or garden hose. Residue like
tobacco smoke may require warm water to be removed.
Alternate Cleaning Option For Homeowners with 200
or 200-1 COLLECTION CELLS ONLY
Vacuuming the PRE-FILTER and COLLECTION CELLS
restores them to a high efficiency. However, some
environmental conditions, like tobacco smoke, cause the
COLLECTION CELLS to need to be washed with water.
Washing the COLLECTION CELLS is acceptable ONLY if the
COLLECTION CELLS have a “200/200-1” embossed or
written on the frame in the vicinity of the manufacturing part
number (Fig. 18).
• Do NOT use soap or detergent in cleaning the COLLEC-
TION CELLS.
• Do NOT immerse the COLLECTION CELLS completely in
water.
• Do NOT place the COLLECTION CELLS into a dishwasher
to clean.
• ALLOW THE COLLECTION CELLS TO DRY THOROUGHLY
BEFORE INSTALLING.
y
u
i
2. After washing, drain as much water as possible from the
COLLECTION CELLS.
3. Holding the sides of the COLLECTION CELLS, gently tap
the cells on a flat surface to dislodge any water droplets
inside the COLLECTION CELLS. After tapping, wipe down
the surfaces of the COLLECTION CELLS to remove any
visible droplets of water.
▲
CAUTION
!
A steady amber light
indicates that the unit is
wired in the 24 V mode.
A blinking amber light
indicates that the unit is
wired in the
communicating mode.
No light present means
that the unit is not
connected.