System information

18 Numbers in [brackets] are for 50 Hz international systems. EAC-SF-13
Service Facts
4. When there are no visible water droplets left in the COL-
LECTION CELLS, reinstall them into the Air Cleaner
cabinet. Be sure to fold the COLLECTION CELLS handles
flat. Refer to Figure 20.
Tap
Gently
5. Replace the door onto the Air Cleaner cabinet.
6. Ensure that the power cord is connected to the Air Cleaner
and press the POWER
button.
Plug Power Cord
in here
Power Button
Amber Light
o
a
NOTE: Once you press the POWER button, the first LED
will be on and it will start flashing after the first 10 [12]
minutes of indoor fan operation. This is normal
operation.
7. On the thermostat, reset the indoor fan operation to the
desired mode. Turn the air system back on at the Comfort
Control (thermostat).
NOTE: The field charger should never be subjected to
water. The field charger should only be cleaned by a
trained service professional.
NOTE: The PRE-FILTER may also be washed ONLY if the
COLLECTION CELLS show a "200/200-1". Follow the
same instructions to wash the PRE-FILTER - being sure
to tap gently and wipe off any visible water droplets.
RESET TIMERS
To reset the PRE-FILTER timer, press and hold the RESET
button until the PRE-FILTER LED turns off. (1 to 2 seconds).
To reset the Collection Cell timer, press and hold the RESET
button until the COLLECTION CELL LED’s turn off. (4 to 5
seconds).
In a communicating system, the filter reset timers can also
be reset at the communicating comfort control. If two air
cleaners are connected on the same system, reset all timers
on both air cleaners at the same time to the same settings.
The comfort control will only report one air cleaner timer and
this methodology will allow the air cleaners to remain on the
same cleaning schedule.
CLEANING THE FIELD CHARGER
1. Turn off the Air Cleaner and remove the Power Door.
2. Bend the FIELD CHARGER metal locking tabs down
against the case.
3. Remove the FIELD CHARGER from the case. Lay the
FIELD CHARGER on a secured flat surface.
FIELD CHARGER PINS ARE SHARP.
DO NOT BEND FIELD CHARGER PINS. WEAR APPROPRI-
ATE GLOVES WHEN HANDLING THE FIELD CHARGER.
FAILURE TO HANDLE FIELD CHARGER PINS PROPERLY
MAY RESULT IN MINOR TO MODERATE INJURY.
4. Wipe down the faceplate of the FIELD CHARGER with a
dry shop towel or use a vacuum cleaner. Do not disas-
semble the FIELD CHARGER.
5. Push a block of styrofoam down over the FIELD
CHARGER Pin.
s
Handles Fold
Flat
p
▲
CAUTION
!
A steady amber light
indicates that the unit is
wired in the 24 V mode.
A blinking amber light
indicates that the unit is
wired in the
communicating mode.
No light present means
that the unit is not
connected.