Installation Guide

ManualsBrandsAmerican Standard ManualsBathPassage 60 in. x 72 in. 2-Piece Glue-Up Alcove Shower Wall and Base Kit with Left Hand Drain in White Subway Tile

755467-100 Rev. A 7/18

DRAIN ASSEMBLY

Strainer

Drain

Body

Shower

Base

Silicone

Sealant

Rubber

Gasket

Fiber

Gasket

Locking

Nut

Rubber

Caulking

Gasket

FIGURE B

Ensure that the floor and stud walls are square and plumb on a

level floor as shown in Figure A. Provide a 5" x 5" (127 x127mm)

opening in the floor for the drain and refer to the product rough-in

for actual drain location. Draw a line 3-1/4" (82mm) above the

level subfloor on the wall studs at each side of the opening.

All of the shower bases require purchasing a round shower strainer type

drain for use with a standard 2" (51mm) plastic schedule 40 waste pipe.

Figure B shows the typical drain assembly. Before installing drain into

the shower base, remove strainer (Fig B). This will be installed after

shower base is in its final position. Cut the waste pipe height so that the

drain body will fit snug in the shower base. Apply silicone sealant

between the drain body and shower base.

FIGURE A

90°

2" (51mm)

PVC Waste Pipe

Opening 5" x 5"

(127 x127mm)

C/L

(See Product Rough-In for Drain Location)

MARK STUDS

ABOVE LEVEL SUBFLOOR

A8012T-CO

NOTE: Drain not included and must be purchased separately.

48"

(1219mm)

24"

(610mm)

16"

(413mm)

34"

(864mm)

2-3/4"

(70mm)

2-1/4"

(57mm)

(25mm)