user manual

M968628 REV.1.3
3
4
5
6
Figure 3.
1
5
7
1
INSTALL VALVE TRIM
1
Figure 1.
Figure 2.
2
1
Figure 1. Remove plaster guard from valve. Push CAP (1)
over VALVE CARTRIDGE (2) until seated against stop.
Figure 2. Make sure O-RING (8) is secure within
ESCUTCHEON HOLDER (3). Push ESCUTCHEON HOLDER
(3) onto CAP (1) and attach with LONG SCREWS (4).
Mount ESCUTCHEON SUPPORT (5) to ESCUTCHEON
HOLDER (3) with 4 SHORT SCREWS (6).
Figure 3. Install ESCUTCHEON (7) onto CAP (1) and push
flush against finished wall. Escutcheon (7) will snap fit onto
ESCUTCHEON SUPPORT (5).
PLSTER
GUARD
Remove pipe cap and plug from shower and tub
rough piping.
Install TUB SPOUT (1) onto tub nipple.
CAUTION: Protect finish on TUB SPOUT when
installing.
Install SHOWER ESCUTCHEON (2) onto SHOWER
ARM (3). Apply sealant or Teflon tape to threads on
both ends of SHOWER ARM (3) and thread longer
leg of SHOWER ARM (3) into shower elbow.
Thread SHOWER HEAD (4) onto SHOWER ARM (3).
PIPE
PLUG
2
INSTALL DIVERTER KNOB, TUB SPOUT, SHOWER HEAD,
SHOWER ARM WITH FLANGE
CAUTION: Protect finish on SHOWER HEAD and
ARM when installing.
Install HANDLE (5) onto CARTRIDGE STEM (6). Tighten
SET SCREW (7) with HEX WRENCH (8) supplied.
PIPE
CAP
SHR.
ELBOW
1
5
7
8
6
TUB FILLER
NIPPLE
3
4
1" MIN.
2
8