Installation Instructions

M965838 (7/18)

RETROFIT SIDE-MOUNT

OPERATOR FOR DIAPHRAGM

FLUSH VALVES

FOR URINAL & TOILET FLUSH VALVES

INSTALLATION

• Remove handle assembly from installed ush valve.

Note: Keeping a rag to prevent water seepage.

• Install FLAT SEAL (2) into FLUSHING UNIT (3).

Install FLUSHING UNIT (3) to FLUSH VALVE (1).

Note: There is a ±13 mm, (±1/2) tolerance for

the 121 mm (4-3/4) dimension.

ACTIVATION

• Remove BATTERY TRAY (1) by loosening SCREW (3).

• Load 4 “C” Alkaline BATTERIES (5) onto BATTERY

TRAY (1).

• Install battery tray into FLUSHING UNIT (2) and tighten

SET SCREW (3) using WRENCH (4) provided.

(Note: last three turns of the wrench will activate the

automatic ushing unit)

Note: Four (4) “C” Cell batteries are not factory installed

inside the Flush unit.

- -

+ +

Fig. 8

Product names listed herein are trademarks of AS America, Inc.

Thank you for selecting American Standard...

the benchmark of ﬁne quality for over 140 years.

To ensure that your installation proceeds smoothly-please

read these instructions carefully before you begin.

INSTALLATION

INSTRUCTIONS

PAGE 1
INSTALLATION INSTRUCTIONS RETROFIT SIDE-MOUNT OPERATOR FOR DIAPHRAGM FLUSH VALVES FOR URINAL & TOILET FLUSH VALVES Thank you for selecting American Standard... the benchmark of fine quality for over 140 years. To ensure that your installation proceeds smoothly-please read these instructions carefully before you begin. INSTALLATION • R emove handle assembly from installed flush valve. Note: Keeping a rag to prevent water seepage. 3 2 • Install FLAT SEAL (2) into FLUSHING UNIT (3).
PAGE 2
ADJUSTING SENSOR DISTANCE; Fig. 9 1. Remove BATTERY TRAY (1) by loosening SCREW (3). Fig. 9 2. Remove FRONT COVER (2) and remove SENSOR ADJUSTMENT TOOL (4). Fig. 9 3. Install BATTERY TRAY (1) and SCREW (3) back into the unit. Fig. 9 4. Press RANGE RESET BUTTON (5) (When object in view, it will flash green light for 7 minute rest period). Fig. 9 5.