Installation Instructions

ManualsBrandsAmerican Standard ManualsBathPatience Bath and 3-Spray Shower Trim Kit with 2.5 GPM in Polished Nickel

1

2

3

- 2 -

Figure 1.

Figure 2.

2

PLASTER

GUARD

1

4

5

1

3

C

H

6

1

M965819 (6/17)

• Figure 1. Remove plaster guard from valve. Push

CAP (1) over VALVE CARTRIDGE (2) until seated

against stop.

• Figure 2. Push ESCUTCHEON (3) onto CAP (1) and

attach to valve body with LONG SCREWS (4) (cut

screws if needed). Mount DECORATIVE PLATE (5) to

ESCUTCHEON (3) by aligning three PINS (6) on back

side of DECORATIVE PLATE (5).

INSTALL VALVE TRIM

2

INSTALL TUB SPOUT, SHOWER HEAD,

SHOWER ARM WITH FLANGE

• Remove pipe cap and plug from shower and tub

rough piping.

• Slip DECORATIVE PLATE (5), then slip TUB SPOUT (1)

onto tub nipple and tighten with 4mm Hex Wrench.

CAUTION: Protect ﬁnish on TUB SPOUT when

installing.

• Install SHOWER ESCUTCHEON (2) onto SHOWER

ARM (3). Apply sealant or Teon tape to threads on

both ends of SHOWER ARM (3) and thread longer

leg of SHOWER ARM (3) into shower elbow.

• Thread SHOWER HEAD (4) onto SHOWER ARM (3).

CAUTION: Protect ﬁnish on SHOWER HEAD and

ARM when installing.

CAUTION

Protect ﬁnish on SHOWER HEAD

and TUB SPOUT when installing.

PIPE

PLUG

PIPE

CAP

4

3

2

SHR.

ELBOW

TUB FILLER

NIPPLE

1-1/2" REF.

2.5 MM HEX

WRENCH

1

5