Installation Guide

PIPE
CAP
1
3
PIPE
PLUG
TUB FILLER
NIPPLE
SHR.
ELBOW
4
2
1-1/2" REF.
Remove pipe cap and plug from shower and tub
rough piping.
Slip TUB SPOUT (1) onto tub nipple and tighten with
4mm Hex Wrench.
CAUTION: Protect finish on TUB SPOUT when
installing.
Install SHOWER ESCUTCHEON (2) onto SHOWER
ARM (3). Apply sealant or Teflon tape to threads on
both ends of SHOWER ARM (3) and thread longer
leg of SHOWER ARM (3) into shower elbow.
Thread SHOWER HEAD (4) onto SHOWER ARM (3).
2
INSTALL TUB SPOUT, SHOWER HEAD,
SHOWER ARM WITH FLANGE
CAUTION: Protect finish on SHOWER HEAD and
ARM when installing.
CAUTION: Protect finish on SHOWER
HEAD and TUB SPOUT when installing.
4MM HEX
WRENCH
INSTALL VALVE TRIM
1
5
4
6
(4) ALIGNMENT
HOLES FOR
DIAL PLATE
1
2
3
When finished tiling the wall, remove PLASTER GUARD (1)
and turn off water supply.
Push CAP (2) over VALVE CARTRIDGE (3).
Mount ESCUTCHEON (4) to valve body with SCREWS (5).
Push DIAL PLATE (6) over CAP (2) and into the four alignment
holes in ESCUTCHEON (4).
M965236