Installation Guide

- 1 -
Product names listed herein are trademarks of AS America, Inc.
© AS America, Inc. 2018
Thank you for selecting American Standard...
the benchmark of fine quality for over 140 years.
To ensure that your installation proceeds smoothly-please read
these instructions carefully before you begin.
RECOMMENDED TOOLS
ROUGHING-IN DIMENSIONS
CARE INSTRUCTIONS:
TOWN SQUARE
®
S
CENTRAL THERMOSTAT WITH
VOLUME CONTROL TRIM KIT
INSTALLATION
INSTRUCTIONS
T455740
Certied to comply with ANSI A112.18.1M
M965902 (4/18)
• To keep your new faucet looking new, please follow
these simple care instructions:
DO:
• Simply rinse the faucet clean with clear water.
• Dry the faucet with a soft cotton cloth.
DO NOT:
• Do not use any abrasive cleaners, cloths, or
paper towels.
• Do not use any cleaning agents containing
acids, polish abrasives, or harsh cleaners or
soaps.
• Regular and routine cleaning will reduce the need for
heavy cleaning and polishing. If heavy cleaning is
required, the following procedures are recommended:
• Remove as much surface dirt and lm using clear
water and soft cotton cloth (as described above).
• Use any of the following to remove tough surface
lm and build-up:
• Mild liquid detergents
• Clear ammonia free liquid glass cleaners
• Non-acidic, non-abrasive gentle liquid or fully dissolved
powder cleansers mixed according to manufacturers
directions.
• Non-abrasive liquid polishers
• Once clean, rinse faucet again with clear water to thoroughly
remove cleaner or polish and blot dry with a soft cotton cloth.
Failure to follow these care instructions may
damage the Faucet’s finish.
Flat Blade Screwdriver
Phillips Screwdriver
C
7-5/16"
(186 mm)
7-1/16"
(179 mm)
1-11/16"
(42 mm)
NOTE: FITTING
MUST BE INSTALLED
WITH VOLUME CONTROL
ON TOP.
R520
1/2" NPT INLETS
or
R540
3/4" NPT INLETS
FINISHED
WALL
9 "
(230 mm)
7-1/2"
(190 mm)
3/4"
(20 mm)
3-15/16"
(74 mm)
3-3/16"
(87 mm)