Installation Guide

- 2 -
VALVE
LOCK RING
FITTING
MOUNTING
DECK
VALVE
LOCK RING
SPOUT
SHANK
HOT
COLD
FRICTION WASHER
MOUNTING NUT
# 8
SCREWS
1
2
3
4
6
5
M965903 (4/18)
2
• Remove PLASTER GUARDS.
• Thread INSERT (1) into SIDE VALVE (2) until it touches the installation surface.
• Thread INSERT (3) into SIDE VALVE (4) until it touches the installation surface.
• Tighten COUPLING (5) into TEE (6) for products without hand shower.
VALVE ASSEMBLY
INSTALL HANDLES
3
• Turn VALVE to OFF position.
• Push ADAPTER (1) on VALVE STEM (2), so that the hole of the ADAPTER (1) without a spline is facing up. Fig. A.
Tighten STEM SCREW (3) to secure ADAPTER (1).
• Align DECK ADAPTER (5) to LEVER HANDLE ASSEMBLY (4). Push LEVER HANDLE
ASSEMBLY (4) onto DECK ADAPTER (5) rmly to ush against mounting surface.
1
2
3
5
6
4
TOP
MALE TEETH
SPLINE END DOWN
Fig. A.
FEMALE TEETH
HEX WENCH
SUPPLIED