User Guide

TOWNSQUARE

Required Tools

Adjustable Wrench

Channel Locks

Flat Blade Screwdriver

Plumbers' Putty or Caulking

Phillips Screwdriver

BATH/SHOWER TRIM KIT

1-5/8" TO 3-1/4"

FINISHED WALL

BOTTOM OF

TUB

74" FOR

HEAD CLEARANCE

2" REF.

18"

OPTIONAL

1/2" I.P.S.

7-5/8"

OPTIONAL TO

FINISHED FLOOR

USUALLY BETWEEN

65'' AND 78''

8" REF.

TOP OF

TUB RIM

1-3/4" REF.

1/2" COPPER

7-1/4" REF.

Certiﬁed to comply with ANSI A112.18.1

M968235 Rev. 1.5

T555.500

T555.501

T555.502

Installation

Instructions

ROUGHING-IN DIMENSIONS

■ To assure proper positioning in relation to

wall, note roughing-in dimensions.

PRESSURE BALANCING BATH

AND SHOWER TRIM KIT

Thank you for selecting American-Standard...the benchmark

of ﬁne quality for over 100 years.

To ensure that your installation proceeds smoothly--please

read these instructions carefully before you begin.

PAGE 1
Installation Instructions TOWNSQUARE T555.500 T555.501 T555.502 BATH/SHOWER TRIM KIT PRESSURE BALANCING BATH AND SHOWER TRIM KIT Thank you for selecting American-Standard...the benchmark of fine quality for over 100 years. To ensure that your installation proceeds smoothly--please read these instructions carefully before you begin. Certified to comply with ANSI A112.18.1 M 9 6 8 2 3 5 R ev. 1.
PAGE 2
1 2 INSTALL TRIM CAUTION: Protect finish on SHOWER ARM, SHOWER HEAD and TUB SPOUT when installing. INSTALL HANDLE Install HANDLE BUSHING (1) onto CAP (2). When finished tiling the wall, remove PLASTER GUARD (A) and turn off water supply. Find correct position of HANDLE (3) and push HANDLE (3) onto VALVE STEM (4). Push CAP (1) over VALVE CARTRIDGE (2). Install HANDLE SCREW (5) and push in INDEX CAP (6). Mount ESCUTCHEON (3) to valve body with SCREWS (4).
PAGE 3
4 TO GAIN ACCESS TO VALVE FOR SERVICING Pull INDEX CAP, unscrew HANDLE SCREW and pull HANDLE off valve stem. Remove two SCREWS holding ESCUTCHEON and remove ESCUTCHEON. Remove COVER by pulling straight out. Shut off water supply by either closing off main water supply, or closing off the hot and cold CHECK STOPS on valve. VALVE LEAKS WHEN SHUT OFF Remove CARTRIDGE (1) by removing CARTRIDGE SCREWS (2). Remove three SCREWS (3) from FIXATION RING (4) and pull out PRESSURE BALANCING (5) unit.