Installation Guide

- 2 -
UP
4
2
UP
1
1
2
UP
1
PLASTER
GUARD
Figure 2.
Figure 1.
Figure 1a.
1
Figure 2a.
4
3
C
H
4
3
C
H
2
4
• Hold ADAPTER (4) onto CARTRIDGE STEM (2) and install ADAPTER SCREW (5)
through ADAPTER (4) into CARTRIDGE STEM (2). Tighten ADAPTER SCREW
(5) to secure ADAPTER (4) to CARTRIDGE STEM (2).
• Install HANDLE (1) by pushing it onto CARTRIDGE STEM (2) and tightening SET
SCREW (3) from below with 2.5 mm Hex Wrench supplied.
HANDLE INSTALLATION
M985000 Rev. 1.0 (3/20)
3
INSTALL TUB SPOUT, SHOWER HEAD,
SHOWER ARM WITH FLANGE
• Remove pipe cap and plug from shower and tub
rough piping.
• Slip DECORATIVE PLATE (5), then slip TUB SPOUT (1) onto tub
nipple and tighten with 4mm Hex Wrench.
CAUTION: Protect nish on TUB SPOUT when installing.
• Install SHOWER ESCUTCHEON (2) onto SHOWER ARM (3). Apply
sealant or Teon tape to threads on both ends of SHOWER ARM (3)
and thread longer leg of SHOWER ARM (3) into shower elbow.
• Thread SHOWER HEAD (4) onto SHOWER ARM (3).
CAUTION: Protect nish on SHOWER HEAD and ARM when
installing.
CAUTION
Protect nish on SHOWER HEAD
and TUB SPOUT when installing.
PIPE
PLUG
PIPE
CAP
4
3
2
SHR.
ELBOW
TUB FILLER
NIPPLE
1-1/2" REF.
2.5 MM HEX
WRENCH
1
5
OFF
1
5
4
2.5MM HEX
WRENCH
3
2
• Figure 1. Remove plaster guard from valve. Push CAP (1)
over VALVE CARTRIDGE (2) until seated against stop.
• Figure 2. Push ESCUTCHEON (3) onto CAP (1) and attach
to valve body with LONG SCREWS (4).
THIN WALL INSTALLATION
• Figure 1a. Push CAP (1) over VALVE CARTRIDGE (2) until
seated against stop.
• Figure 2a. Push ESCUTCHEON (3) onto CAP (1) and attach
to valve body with LONG SCREWS (4).
STANDARD WALL INSTALLATION